Nokia 8210 Command List

AT Command Set for Nokia 8210 67
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
+CKEV Keypad Event
+CKEV: <key>,<press>
- when +CMER=2:
only last indication of each <key> value is buffered if in on-line data state
- when +CMER=3 and V.80 in-band mode is enabled:
all events are forwarded directly to TE
- when +CMER=3 and V.80 in-band mode is disabled or not supported:
behaves like +CMER=2 case
See also command +CMER, page 21. (GSM 07.07 section 8.10).
+CLIP Calling Line Identification Report
+CLIP: <number>,<type>[, <subaddr>,<satype>[,<alpha>]]
is given when +CLIP=1 and and number received from network when MT call
received (no active or held calls in ME).
This result code is sent to TE after every RING (or +CRING) result code. Subaddress
and alpha not supported by NMP products. (GSM 07.07 section 7.6).
+CME ERROR Mobile Equipment Error
+CME ERROR: <err>
is given instead of ERROR when +CMEE=1 or =2 and error is related to ME or
network operation.
See also the Error Values section, page 56. (GSM 07.07 section 9.2).
+COLP Connected Line Identification Report
+COLP: <number>,<type>[,<subaddr>,<satype>[,<alpha>]]
is given when +COLP=1 and number received from network when MO call
established.
This intermediate result code is given after (possible) +CSSI result code. Subaddress
and alpha not supported by NMP products. (GSM 07.07 section 7.8).
+CR Data service report
+CR: <type>
is given when +CR=1 and data call established; informs about the type of data call
being established.
This intermediate result code is given after (possible) +COLP result code during MO
data call setup. During MT data call setup this is the first intermediate result code.
Note that this result code shall replace CARRIER result code (when X5 is set). (GSM
07.07 section 6.9).
+CREG Network Registration
+CREG: <stat>[,<lac>,<cid>]
- when +CREG=1:
given when <stat> value changes; given after NO CARRIER if network lost when on-
line
- when +CREG=2:
given when <stat> value changes and when network cell (<lac> and <cid>) of ME
changes; given after NO CARRIER if network lost when on-line; if V.80 is enabled,
result code is sent in-band during on-line data mode
(GSM 07.07 section 7.2).

Nokia 8210 Specifications

General

Display	Monochrome graphic
Resolution	5 lines
Weight	79 g
Battery	Removable Li-Ion 650 mAh battery (BLB-2)
Stand-by	Up to 150 h
Talk time	Up to 3 h
Released	1999
Announced	1999
Status	Discontinued
SIM	Mini-SIM
Alert types	Vibration; Monophonic ringtones
2G bands	GSM 900 / 1800
Messaging	SMS
Phonebook	250 entries
Games	Memory, Snake
Colors	Red, Blue, Green
Dimensions	101.5 x 44.5 x 17.4 mm, 69 cc (3.98 x 1.75 x 0.69 in)