Nokia 8210 - Page 67

AT Command Set for Nokia 8210 66
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
De Facto Result Codes
Call Repeat Restriction Result Codes
BLACKLISTED and DELAYED. See dialling command D, page 46.
This mechanism is mandatory. (GSM 02.07 Annex A).
CARRIER Error Control Negotiation Start
Some products may choose to send CARRIER (numeric V0 value 16) intermediate
result code when data call is originated (or answered) and error control (RLP, V.42,
MNP) negotiation starts (code is also sent when there is no negotiation).
This code is given after (possible) +COLP result code during MO data call setup.
During MT data call setup this is the first intermediate result code. Note that if +CR
result code sending is active, it shall replace this code. See also command X, page
52.
GSM 07.07 Result Codes
+CCWA Call Waiting
+CCWA: <number>,<type>,<class>[,<alpha>]
is given when +CCWA=1 and incoming MT call is received when there is active or
held calls in ME (discarded if in on-line data state and V.80 in-band mode is disabled
or not supported).
Note that this result code is not repeated similarly as RING, but given only once.
Alpha not supported by NMP products. (GSM 07.07 section 7.11).
+CDEV Display Event
+CDEV: <elem>,<text>
- when +CMER=2:
only last indication of each value is buffered if in on-line data state
- when +CMER=3 and V.80 in-band mode is enabled:
all events are forwarded directly to TE
- when +CMER=3 and V.80 in-band mode is disabled or not supported:
behaves like +CMER=2 case
See also command +CMER, page 21. (GSM 07.07 section 8.10).
+CIEV Indicator Event
+CIEV: <ind>,<value>
- when +CMER=2:
only last indication of each <ind> value is buffered if in on-line data state
- when +CMER=3 and V.80 in-band mode is enabled:
all events are forwarded directly to TE
- when +CMER=3 and V.80 in-band mode is disabled or not supported:
behave like +CMER=2 case
See also command +CMER, page 21. (GSM 07.07 section 8.10).