AT Command Set for Nokia 8210 27
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
Syntax:
text mode (+CMGF=1):
AT+CNMA
PDU mode (+CMGF=0):
AT+CNMA=<n>,<length><CR>
PDU is given<ctrl-Z/ESC>
AT+CNMA=?
Show supported values.
Response for PDU mode (+CMGF=0) is:
+CNMA: (0-2)
+CNMI New Message Indications to TE
This command selects the procedure how the receiving of new messages from the
network is indicated to the DTE. For a detailed description of the syntax of indication
responses, see Result Codes at page 65. (GSM 07.05 section 3.4.1)
Syntax:
AT+CNMI=[<mode> [,<mt> [,
<bm> [,<ds> [,<bfr>]]]]]
Select indication procedure.
AT+CNMI?
Query current setting.
Response is +CNMI: <mode>, <mt>,
<bm>, <ds>, <bfr>.
AT+CNMI=?
Show valid values. Response is +CNMI:
lists of supported (<mode>'s), (<mt>'s),
(<bm>'s), (<ds>'s), (<bfr>'s).
Parameters:
<mode>
0 buffer all indications
1 no indications when the DTE-DCE link is reserved (on-line data mode)
2 buffer indications when the DTE-DCE link is reserved, (e.g. in on-line
data mode), and flush them to the DTE after reservation has ended
<mt>
0 no received message indications are routed to the DTE
1 indication of received message is routed to the DTE using a result
code +CMTI
2 received messages (except class 2 messages which result only +CMTI
indication) are routed directly to the DTE using a result code +CMT
3 class 3 received messages are routed directly to the DTE using a
result code +CMT and messages of other classes using a result
indication +CMTI
<bm>
0 no cell broadcast indications are routed to the DTE
2 new cell broadcast messages are routed directly to the DTE using a
result code +CBM
<ds>
0 no status reports are routed to the DTE
1 status reports are routed to the DTE using a result code +CDS
<bfr>
0 buffer of indications is flushed to the DTE when <mode> 1 or 2 is
entered
1 buffer of indications is cleared when <mode> 1 or 2 is entered
To Next Page
Loading...
