AT Command Set for Nokia 8210 38
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
+CSMS Select Message Service
This commands selects the messaging service and returns the type of messages
supported. Supported service is specified by GSM 03.40 and 03.41 (service value 0).
If chosen service is not supported by the ME (but is supported by the TA), final result
code +CMS ERROR: shall be returned. Main difference between 0 and 1 is that
when =1 +CNMA acknowledgement is required to most MT short messages routed
directly TE. (GSM 07.05 section 3.2.1.)
Syntax:
AT+CSMS=<service>
Select message service.
Response is +CSMS: 1,1,1 or 1,1, 0.
Default setting is 0.
AT+CSMS?
Query current setting.
Response is +CSMS: <service>,1,1,1 or
+CSMS: <service>,1,1,0.
AT+CSMS=?
Show supported services.
Response is +CSMS: (0,1) or (0).
Parameters:
<mt>, <mo>, <bm>:
0 type not supported
1 type supported
<mt>: mobile terminated messages supported (value 1) or not (value 0)
<mo>: mobile originated messages supported (value 1) or not (value 0)
<bm>: broadcast type messages supported (value 1) or not (value 0)
+CSNS Single Numbering Scheme
This command is used to select the bearer service to be used when a call without
bearer service capability element is received. The command must be given before
the call comes. Parameter values set with the command +CBST are used when
<mode> equals to a data service. (GSM 07.07 section 6.16.)
Syntax:
AT+CSNS=<mode>
Set single numbering scheme mode. The
default option is 0.
AT+CSNS?
Query current setting.
Response is +CSNS: <mode>
AT+CSNS=?
Show supported modes.
Response is +CSNS: (list of supported
<mode>'s).
Values for <mode>:
0
voice (default)
1
alternating voice/fax, voice first
(teleservice 61)
2
fax (teleservice 62)
3
alternating voice/data, voice first
(teleservice 61)
4
data
5
alternating voice/fax, fax first (teleservice
61)
6
alternating voice/data, data first (bearer
service 61)
7
voice followed by data (bearer service 81)
To Next Page
Loading...
Need help?
General
