AT Command Set for Nokia 8210 24
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
+CMGR Read Message
This command returns a message with a location value <index> from a preferred
message storage selected with the AT+CPMS command. If status of the message is
'received unread', status in the storage changes to 'received read'. If reading fails,
final result
code +CM
S ERROR: <err> is returned
. <alpha
> and CBM
memory are
not supported by NMP products. (GSM 07.05 section 3.4.3.)
Syntax:
AT+CMGR=<index>
Responses:
text mode (+CMGF=1), SMS-DELIVER:
+CMGR:
<stat>,<oa>,[<alpha>],<scts>[,<tooa>,
<fo>,<pid>,<dcs>,<sca>,<tosca>,<length>
] <CR><LF><data>
text mode (+CMGF=1), SMS-SUBMIT:
+CMGR:
<stat>,<da>,[<alpha>][,<toda>,<fo>,
<pid>,<dcs>,[<vp>],<sca>,<tosca>,<lengt
h>] <CR><LF><data>
text mode (+CMGF=1), SMS-STATUS-
REPORT:
+CMGR:
<stat>,<fo>,<mr>,[<ra>],[<tora>],<scts>,dt
>,<st>
text mode (+CMGF=1), SMS-
COMMAND:
+CMGR:
<stat>,<fo>,<c
t>[,<pid>
,[<mn>],[
<da>],
[<toda>],<length><CR><LF><cdata>]
PDU mode (+CMGF=0):
+CMGR:
<stat>,[<alpha
>],<leng
th><CR><LF><p
du
>
AT+CMGR=?
Shows whether command has been
implemented.
+CMGS Send Message
This command sends a message to the network. A message reference value <mr> is
returned to the DTE on successful message delivery. Sending can be cancelled by
using the <ESC> character. <ctrl-Z> must be used to indicate the ending of the
message body. Values can be used to identify message upon unsolicited delivery
status report result code. If sending fails in a network or an ME error, final result code
+CMS ERROR: <err> is returned. (GSM 07.05 section 3.5.1.)
Syntax:
text mode (+CMGF=1):
AT+CMGS=<da>,<toda><CR>
text is entered<ctrl-Z/ESC>
Response when text mode (+CMGF=1)
and sending ok: +CMGS: <mr>[,<scts>]
PDU mode (+CMGF=0):
AT+CMGS=<length><CR>
PDU is given<ctrl-Z/ESC>
Response when PDU mode (+CMGF=0)
and sending ok: +CMGS:
<mr>[,<ackpdu>]
Default option for text mode: [,129/145]
To Next Page
Loading...
Need help?
General
