AT Command Set for Nokia 8210 17
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
+CIND Indicator Control
Queries the current status of ME physical indicators. Number of supported <ind>s
depend on the product. Indicator writing not supported by NMP products ('set'
command returns always ERROR, or +CME ERROR when allowed by +CMEE).
Note that all indicators that can be read with +CIND? must also be available as
unsolicited +CIEV result codes (if +CMER=? indicates that +CIEV codes are
supported). (GSM 07.07 section 8.9.)
Syntax:
AT+CIND=
AT+CIND?
Query current setting.
Response is +CIND: <ind>[,<ind>[,...]]
AT+CIND=?
Show supported values.
Response is +CIND:(list of supported
<ind>'s)
Parameters:
<ind>: integer type value, which shall be in range of corresponding <descr>
<descr> values reserved and their <ind> ranges:
"battchg"
battery charge level (0-5)
"signal"
signal quality (0-5)
"service"
service availability (0-1)
"sounder"
sounder activity (0-1)
"message"
message received (0-1)
"call"
call in progress (0-1)
"vox"
transmit activated by voice activity (0-1)
"roam"
roaming indicator (0-1)
"smsfull"
a short message memory storage in the
MT has become full (1), or memory
locations are available (0); i.e. the range is
(0-1)
To Next Page
Loading...
Need help?
General
