Nokia 8210 - S3 Command Line Termination Character; S4 Response Formatting Character; S5 Command Line Editing Character; S6 Pause before Blind Dialling

AT Command Set for Nokia 8210 50
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
Syntax:
ATS2=<n>
Values for <n>are 0..127 (default 43)
ATS2?
Query current setting.
Response is <n>.
S3 Command Line Termination Character
Default character is carriage return. The setting is also used in result code and
information response formatting. See also command V, page 52. (V.25ter section
6.2.1. )
Syntax:
ATS3=<n>
Set termination character. Default is 13.
ATS3?
Show valid values. Response is <n>.
Values for <n>:
000
...
127
S4 Response Formatting Character
Default character is line feed. See also command V, page 52. (V.25ter section 6.2.2.)
Syntax:
ATS4=<n>
Set response formatting character. Default
is 10.
ATS4?
Show valid values. Response is <n>.
Values for <n>:
000
...
127
S5 Command Line Editing Character
Default character is backspace. (V.25ter section 6.2.3.)
Syntax:
ATS5=<n>
Set response formatting character.
Default is 8.
ATS5?
Show valid values. Response is <n>.
Values for <n>:
000
...
127
S6 Pause Before Blind Dialling
This setting is ignored. (V.25ter section 6.3.9.)
Syntax:
ATS6=<n>
Values for <n> are 2..10.
ATS6?
Query current setting.
Response is <n>.