AT Command Set for Nokia 8210 28
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
+CNUM Subscriber Number
Returns MSISDNs from SIM. <speed>, <service> and <itc> are not supported by
NMP products. (GSM 07.07 section 7.1.)
Syntax:
AT+CNUM
Response is +CNUM: [<alpha1>],
<number1>, <type1>[, <speed>,
<service> [,<itc>]] [<CR> <LF>+CNUM:
[<alpha2>],
<number2>,<type2>[,<speed>,
<service>[,<itc>]] [...]]
AT+CNUM=?
Shows whether command has been
implemented.
Parameters:
<alphax>: optional alphanumeric string associated with <numberx>; used character
set should be the one selected with command Select TE Character Set +CSCS
<numberx>: string type phone number of format specified by <typex>
<typex>: type of address octet in integer format (GSM 04.08, subclause 10.5.4.7)
<speed>: as defined in subclause 6.7
<service>:
service related to the phone number:
0
asynchronous modem
1
synchronous modem
2
PAD Access (asynchronous)
3
Packet Access (synchronous)
4
voice
5
fax
also all other values below 128 are
reserved
<itc>:
information transfer capability:
0
3.1 kHz
1
UDI
+COLP Connected Line Identification Presentation
Controls presentation of +COLP intermediate result code or returns COLP
subscription status from network. If product does not support network status query,
<m> shall always equal 2. (GSM 07.07 section 7.8.)
Syntax:
AT+COLP=
Select bearer service type. The default
option is 0.
AT+COLP?
Query current setting.
Response is +COLP: <n>,<m>
AT+COLP=?
Show supported values.
Response is +COLP: (list of supported
<n>'s).
Parameters:
<n >:
parameter sets/shows the result code
presentation status in the TA:
0
disable
1
enable
<m >:
parameter shows the subscriber COLP
service status in the network:
0
COLP not provisioned
1
COLP provisioned
2
unknown (e.g. no network, etc.)
To Next Page
Loading...
Need help?
General
