Nokia 8210 - Page 69

AT Command Set for Nokia 8210 68
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
+CRING Distinctive Ring
+CRING: <type>
is given when +CRC=1 and incoming MT call (no active or held calls in ME).
Note that this code replaces the V.25ter RING result code. (GSM 07.07 section 6.11).
+CSSI Intermediate Supplementary Service Notification
+CSSI: <code1>[,<index>]
is given when +CSSN=1 and some supplementary service notification is given by
network during MO call establishment.
This is the first intermediate result code after dial command D. Supported <code1>'s
depend on the supplementary services implemented in a product. (GSM 07.07
section 7.2).
+CSSU Unsolicited Supplementary Service Notification
+CSSU: <code2>[,<index>[,<number>, <type>[,<saddr>,<satype>]]]
is given when +CSSN=,1 and some supplementary service notification is given by
network during MT call setup or during a voice call; note that also remote release of a
held call is informed with this result code.
In MT call setup case, this result code is sent to TE after every (possible) +CLIP
result code. In case of a waiting call, this is given after +CCWA result code (but
discarded if TA is in on-line data state and V.80 in-band mode is disabled or not
supported). Supported <code2>'s depend on the supplementary services
implemented in a product. (GSM 07.07 section 7.16).
+CUSD Network Initiated Unstructured Supplementary Service Data
+CUSD: <m>,<str>,<dcs>
is given when +CUSD=1 and network initiated 'notify' or 'request' USSD message
received; discarded if in on-line data state (also when V.80 in-band mode is enabled).
Note that only the first 'request' message during a network initiated USSD session
yields to this unsolicited result code. Rest are information responses of +CUSD
command. (GSM 07.07 section 7.14).
GSM 07.05 Result Codes
+CBM New CBM
text mode:
+CBM: <sn>,<mid>,<dcs>,<page>,<pages><CR><LF><data>
PDU mode:
+CBM: <length><CR><LF><pdu>
- when +CNMI=0:
messages are discarded
- when +CNMI=1-3:
messages are forwarded directly to TE (CBMs cannot be received during a call)
See also command +CNMI, page 27. (GSM 07.05 section 3.4.1).