AT Command Set for Nokia 8210 19
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
For some products <fac>="NT" is only applicable with Nokia 8110 and compatible
phones.
Syntax:
AT+CLCK=<fac>,
<mode>, <passwd>,
<class>
When <mode>=2: the response is
+CLCK: <status>[,<class1>
[<CR><LF>+CLCK: <status>,<class2>
[...]]].
The default option is [,,,7].
AT+CLCK=?
Show supported values.
Response is +CLCK:(list of supported
<fac>'s).
Parameters:
<fac>:
"CS"
CNTRL (lock CoNTRoL surface (e.g.
phone keyboard))
"PS"
PH-SIM (lock PHone to SIM card) (ME
asks password when other than current
SIM card inserted)
"SC"
SIM (lock SIM card) (SIM asks password
in ME power-up and when this lock
command issued)
"AO"
BAOC (Barr All Outgoing Calls)
(GSM 02.88, clause 1)
"OI"
BOIC (Barr Outgoing International Calls)
(GSM 02.88, clause 1)
"OX"
BOIC-exHC (Barr Outgoing International
Calls except to Home Country)
(GSM 02.88, clause 1)
"AI"
BAIC (Barr All Incoming Calls)
(GSM 02.88, clause 2)
"IR"
BIC-Roam (Barr Incoming Calls when
Roaming outside the home country)
(GSM 02.88, clause 2)
"NT"
barr incoming calls from numbers Not
stored to TA memory
"NM"
barr incoming calls from numbers Not
stored to ME memory
"NS"
barr incoming calls from numbers Not
stored to SIM memory
"NA"
barr incoming calls from numbers Not
stored in Any memory
"AB"
All Barring services (GSM 02.30)
"AG"
All outGoing barring services (GSM 02.30)
"AC"
All inComing barring services
(GSM 02.30)
"FD"
SIM fixed dialling memory feature (if PIN2
authentication has not been done during
the current session, PIN2 is required as
<passwd>)
<mode>:
0
unlock
1
lock
2
query status
<status>:
0
not active
1
active
<passwd>: string type; shall be the same as password specified for the facility from
the ME user interface or with command Change Password +CPWD
To Next Page
Loading...
Need help?
General
