AT Command Set for Nokia 8210 60
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
+CME ERROR Values: Kinds of Errors
1
phone security code required to execute the AT command
2
ME does not have a SIM connected to it
3
SIM PIN required to execute the AT command
4
SIM PUK required to execute the AT command
5
phonebook memory location does not exist
6
phonebook memory location is empty
7
match in searched string is not found from any of the memory
locations
8
general memory error; e.g. problems in SIM database
communication
9
call hold/retrieve/swap/build/split/transfer/deflection failed or
cannot be actioned
10
manual network selection is not possible because unavailable
or forbidden network name was given, or call is active
11
invalid password was given
12
SIM PUK2 required to execute the AT command
13
there is no network service to complete the request
14
supplementary service command failed due to an unknown
error; i.e. an error that is not covered by other <err> values
15
AT interpreter does not support the operation (in case of
+CLCK= when <fac>="AB" or ="AG" or ="AC" but <mode>¹0; in
case of +CPBW= when <index> is not given but <number> is)
16
SIM PIN2 required to execute the AT command
17
alpha entry to be stored is too long
18
number to be read/stored is too long
19
number to be stored contains characters that are not available
in that memory
21
external ME is not connected to TA; this is not applicable to
products that have ME and TA in one entity
22
external ME UI cannot be accessed
23
network timeout
24
entries cannot be stored in currently selected phone book
memory (e.g. in missed calls list)
25
there is no active voice call
To Next Page
Loading...
Need help?
General
