3 Performing the Initial Configuration
42 Nokia EM5400 IP Security Platform (IP260 and IP265 Appliances) Installation Guide
Note
A physical ID identifies the network interface type (eth) and the port
number (port-num).
The physical ID syntax is:
ethport-num
After you complete the initial configuration, use Nokia Network
Voyager to configure the remaining network ports.
Connecting Network Interfaces
Connect at least one network interface to the network to use as the Nokia
Network Voyager system-management interface.
You can also connect the remaining Ethernet interface cables at this point,
although you are not required to do so.
To connect 10/100 Ethernet devices, use a straight-through cable with an
RJ-45 connector to connect to a 10-Mbps or 100-Mbps hub.
For further details, see “Connecting to Ethernet Ports” on page 48.
You can use Nokia Network Voyager or the command-line interface (CLI) to
configure the remaining network ports on your EM5400 appliance. Details
about how to use Network Voyager, the CLI, and Nokia Horizon Manager are
provided in the following sections.
Using Nokia Network Voyager to Manage Your
Appliance
Use Nokia Network Voyager to configure and monitor your appliance. For
additional information about how to use Network Voyager, see “Using Nokia
EM5400 IP Security Platform includes IP260, IP265, 50i, 50s Appliances
To Next Page
Loading...
