7 Using the Nokia IPSO Boot Manager
60 Nokia EM5400 IP Security Platform (IP260 and IP265 Appliances) Installation Guide
your own needs, or you can use different parameters in the command line at
boot time. The boot manager maintains the default values of these parameters
on the compact flash memory. You can set these values by using boot manager
commands.
This chapter discusses the boot manager commands.
To enter the boot manager
1. Connect to the EM5400 appliance with a console connection.
2. Boot the system.
The following text appears:
Starting bootmgr
Loading boot manager.
Boot manager loaded.
Entering autoboot mode.
Type any character to enter command mode.
3. Press any key when the Type any character to enter command mode text
appears.
The boot manager command prompt appears:
BOOTMGR[1]>
If you do not press a key, the system continues to boot.
4. Enter
boot to exit the boot manager and continue booting.
Boot-Manager Variables
The boot manager stores a number of variables in non-volatile memory. You
can set and view most variables from the boot manager prompt. Table 5 lists
the boot-manager variables.
EM5400 IP Security Platform includes IP260, IP265, 50i, 50s Appliances
To Next Page
Loading...
