RF key components
Figure 15 RF key components
Auto tuning
Introduction to auto tuning
This phone can be tuned automatically.
Auto tune is designed to align the phone's RF part easier and faster. It performs calibrations, tunings and
measurements of RX and TX. The results are displayed and logged in a result file, if initiated.
Hardware set up
Hardware requirements for auto tuning:
•
PC (Windows 2000/XP) with GPIB card
•
PK-1/PDK-1 service dongle
•
Power supply
•
Product specific module jig
•
Cables: RF cable XRS-6, USB cable, GBIP cable and MBUS cable DAU-9S
•
Signal analyser (TX), signal generator (RX) and RF-splitter or one device including all.
RM-632; RM-634; RM-699
RF troubleshooting
Page 4 – 6 COMPANY CONFIDENTIAL Issue 3
Copyright © 2010 Nokia. All rights reserved.
To Next Page
Loading...
