System Setup
3-11
Part 1604857-04
E 2014 Nordson Corporation
Spray Gun Connections
Unpack the spray gun. Uncoil the cable, the 4-mm clear and 6-mm black air
tubing, and the 11-mm powder hose. Make the following connections:
Gun Cable
See Figure 3-11.
1. Connect the gun cable to the GUN receptacle on the rear panel of the
controller. The cable plug and receptacle are keyed.
2. Thread the cable nut onto the receptacle and tighten the nut securely.
3. Secure the cable strain relief to the rear panel with one of the existing
panel screws.
Mobile System
Rail/Wall Mount System
Strain Relief
Figure 3-11 Gun Cable Connection and Strain Relief Mounting
To Next Page
Loading...
