Repair
6-2
Part 1604857-04
E 2014 Nordson Corporation
Gun Disassembly (contd)
4. See Figure 6-2. Remove the black nylon screw (22) from the gun body.
5. Grasp the handle in one hand and the gun body in the other. Press the
thumbs of each hand together while pulling in opposite directions to
separate the gun body from the handle. The air wash tubing will prevent
a complete separation; leave it connected unless it must be replaced.
22
Figure 6-2 Removing the Gun Body from the Handle
Power Supply Replacement
NOTE: If replacing the powder path, skip this procedure.
1. Slide the power supply (5) out of the gun body.
2. Check the gasket (6) on the back of the bulkhead (7). Replace it if it is
damaged. The gasket is stuck to the bulkhead with pressure-sensitive
adhesive.
5
6
7
Figure 6-3 Removing the Power Supply from the Gun Body
3. Slide the new power supply into the upper cavity of the gun body,
guiding the gun body ribs between the raised grooves on the top of the
power supply.
To Next Page
Loading...
