Repair
6-1
Part 1604857-04
E 2014 Nordson Corporation
Section 6
Repair
WARNING: Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
Spray Gun Repair
NOTE: All item numbers in the spray gun repair illustrations are the same
as the item numbers in the spray gun parts list.
Power Supply and Powder Path Replacement
Gun Disassembly
1. See Figure 6-1. Remove the nozzle nut, nozzle, and electrode assembly
(1, 2, 3).
2. Remove the screws (11, 12) and hook, cover, and housing (8, 9, 10).
3. Pull the power supply harness out of the bulkhead, then insert a small
flat-bladed screwdriver into the recess in the harness connector to
release the catch. Disconnect the gun cable from the power supply
harness.
1
2
3
12
11
8
9
10
Power Supply Connectors
Trigger Connectors
Figure 6-1 Gun Disassembly
1. Nozzle nut
2. Nozzle
3. Electrode assembly
8. Cover
9. Housing
10. Hook
11. M3 x 30 screw
12. M3 x 20 screw
To Next Page
Loading...
