Nortec GS - 3 Receiving and Storage; Inspection; Storage and Transportation

7Receiving and Storage
Nortec GS
2583703_EN_1608
3 Receiving and Storage
3.1 Inspection
All Nortec products are shipped F.O.B at the factory. All damage, breakage or loss claims are the re-
sponsibility of the shipping company.
After receiving the shipment, inspect the goods as follows:
– Inspect the shipping boxes for damage. Report any shipping box damages to the shipping company
without delay.
– Check the goods against the packing slip to ensure that all items have been delivered. Report any
shortages to your Nortec representative within 48 hours of receipt of the goods. Nortec does not
assume responsibilities for any shortages beyond this period.
– Unpack the parts/components and check for any damage.
If parts/components are damaged, notify the shipping company immediately.
– Verify the model type on the specication label to ensure that it is suitable for your installation. Refer
to Figure 3 on page 10.
3.2 Storage and Transportation
Storage
Store the Nortec GS humidier in its original packaging inside a protected area that meets the follow-
ing requirements until it is installed. These requirements also apply if the unit needs to be stored for an
extended period of time.
– Room temperature: 41 to 104°F (5 to 40°C)
– Room humidity: 10 to 75% RH
Transportation
For optimum protection always transport the unit and components in their original packaging, and use
appropriate lifting/transporting devices.
Packaging
Keep the original packaging of the unit/components for later use.
If the packaging needs to be disposed off, observe local regulations on waste disposal. Recycle pack-
aging where possible.