MODE SECTION
Page 8 looks like so:
Pressing the Write button while this page is displayed starts the Restore procedure.
As can be seen the parameter is “Restore from ROM:”. In this case with a value of One program.
This parameter allows the factory Programs, Performances & Global data & Arp Pattern data to be restored to the Factory settings.
Use the lower Fast Data knob to adjust this parameter. Whatever selection is made with the lower Fast Data knob is restored into
memory ( ERASING WHAT WAS THERE!!) when the “Write” button is pressed while in this mode. Additional pages appear
depending on the selection. i.e. if “All data” is selected Nova asks for confirmation which is set with the lower Fast Data knob, if
you set this to “Yes” & press the “Write” button again all the factory setting will be restored. If however “One prog” was selected
Nova asks which Program you want to restore, which is selected using the lower Fast Data knob, & then pressing the “Write” but-
ton again Nova asks for the location ( Program bank & number ) that you wish to store the program in. The range of this parameter
is One prog, One perf, One patt, All progs, All perfs, All patts, Prog Ch table, Globals, All data, Prog bank A, Prog bank B & Perf
bank A.
Page 9 looks like so:
Input 2 on the Nova can double as a Expression pedal / Sustain pedal input.
As can be seen the higher parameter is “Pedal mode”. In this case with a value of Off.
This parameter determines what Input 2 is going to do. In the Off position the Input 2 is configured for use as an Audio Input. In the
Breath-R position, Input 2 is configured to work as an expression pedal input & is re-mapped into breath controller. In this case an
expression pedal with the control output on the ring of the pedal jack. In the Breath-T position, Input 2 is configured to work as an
expression pedal input & is re-mapped into breath controller. In this case an expression pedal with the control output on the tip of
the pedal jack. i.e. a Korg EXP2 expression pedal. In the Sustain position Input 2 is configured to work as an sustain pedal input.
In this case a sustain pedal that is normally open. In the Sustain-I position Input 2 is configured to work as an sustain pedal input.
In this case a sustain pedal that is normally closed. Use the higher Fast Data knob to adjust this parameter. The range of this
parameter is Off, Breath-T, Breath-R, Sustain & Sustain-I. This parameter is memorised as Global.
As can be seen the lower parameter is “Headphones out”. In this case with a value of 1 & 2.
This parameter determines if the Headphone outputs ( Outputs 5&6 ) are configured for use as Headphones or as separate out-
puts. Use the lower Fast Data knob to adjust this parameter. In the 1 & 2 position the Headphones monitor signals from outputs 1
& 2. In the 3 & 4 position the Headphones monitor signals from outputs 3 & 4. In the 5 & 6 position the Headphones can be used
as additional outputs 5 & 6. In the Mix position the Headphones monitor signals from outputs 1, 2, 3, 4, 5 & 6.The range of this
parameter is 1 & 2, 3 & 4, 5 & 6 & Mix. This parameter is memorised as Global.
Pedal mode Off
Headphones out 1 & 2
To Next Page
Loading...
