This does not apply to the Noise, 1*3 & 2*3 Ring Modulator outputs. No audible effect to these sound sources will be heard if an
attempt is made to adjust this parameter when these sound sources are selected & the display will show “Not Available”.
Sync - Button
Mod Depth - Knob
Wheel - Button
This combination controls the modulation of the Sync Effect on the selected Oscillator by the Mod Wheel. Turning the Mod Depth
Knob fully clockwise introduces Sync Effect from the Mod Wheel to the selected Oscillator in a Positive direction. Turning the Mod
Depth Knob fully anticlockwise introduces Sync Effect from the Mod Wheel to the selected Oscillator in a Negative direction. In the
“Mid” position there is no modulation at all. The range of this parameter is -64 to +63.
This does not apply to the Noise, 1*3 & 2*3 Ring Modulator outputs. No audible effect to these sound sources will be heard if an
attempt is made to adjust this parameter when these sound sources are selected & the display will show “Not Available”.
Soften - Button
Level - Knob
This combination controls the Soften Effect on the selected Oscillator & noise waveforms. Turning the Level Knob fully clockwise
introduces the Soften effect fully to the selected Oscillator & fully anticlockwise there is no Softening at all. The range of this
parameter is 000 to 127.
This does not apply to the 1*3 & 2*3 Ring Modulator outputs. No audible effect to these sound sources will be heard if an attempt
is made to adjust this parameter when these sound sources are selected & the display will show “Not Available”.
Soften - Button
Mod Depth - Knob
LFO 1 - Button
This combination controls the modulation of the Soften effect of the selected Oscillator by LFO 1. Turning the Mod Depth Knob fully
clockwise introduces Soften from LFO 1 to the selected Oscillator in a Positive direction. Turning the Mod Depth Knob fully anti-
clockwise introduces Soften from LFO 1 to the selected Oscillator in a Negative direction. In the “Mid” position there is no modula-
tion at all. The range of this parameter is -64 to +63.
This does not apply to the Oscillators that have the, 1*3 & 2*3 Ring Modulator outputs. No audible effect to these sound sources
will be heard if an attempt is made to adjust this parameter when these sound sources are selected & the display will show “Not
Available”.
Soften - Button
Mod Depth - Knob
LFO 2 - Button
This combination controls the modulation of the Soften Effect on the selected Oscillator by LFO 2. Turning the Mod Depth Knob fully
clockwise introduces Soften Effect from LFO 2 to the selected Oscillator in a Positive direction. Turning the Mod Depth Knob fully anti-
clockwise introduces Soften Effect from LFO 2 to the selected Oscillator in a Negative direction. In the “Mid” position there is no modu-
lation at all. The range of this parameter is -64 to +63.
This does not apply to the 1*3 & 2*3 Ring Modulator outputs. No audible effect to these sound sources will be heard if an attempt
is made to adjust this parameter when these sound sources are selected & the display will show “Not Available”.
To Next Page
Loading...
