Filter Modulation Matrix
This is an extremely powerful feature of the Nova. These controls effect the modulation of the Filter. The Buttons on the left are
“Destinations”. They can all be modulated by the “Sources” which are the buttons on the right. The amount of modulation applied
from any source is determined by the setting of the Mod Depth Knob. This can be either positive modulation ( Turning the Mod
Depth Knob Clockwise ) or negative modulation. ( Turning the Mod Depth Knob Anticlockwise )
For example to adjust the level of Envelope 2 modulation of the the “Freq” setting of the Filter press the “Frequency” button to
define the modulation destination, it will light up indicating it is selected. Press the Env 2 button to define the modulation source.
Now adjusting the “Mod depth” knob clockwise will modulate the Frequency setting of the Filter by Envelope 2.
This makes it possible for all modulation sources to effect any one destination in varying amounts & even in different polarities.
The display will change to indicate the parameter that has been selected & display the newly edited value. The Display will stay
like this until another parameter is adjusted, in which case it will change to display the new parameter. To return to the display of
the Program / Performance name & number press the Program or Performance button.
Only one source & destination can be edited at one time.
Even though only one source & destination combination can be edited at one time, all available combinations can happen at the
same time.
To Next Page
Loading...
