Nytech DC-8200 Introduction
10 - English
Insert the rechargeable batteries in the charger BC024F-UK so that the
contacts [+] and [-] on the rechargeable batteries and charging cradle
markings match.
Figure: Opened charger with polarity
markings
Plug the charger into a wall outlet.
The status indicators of the charging cradle will light yellow whilst the
batteries are charging. When the charging process is completed, the status
indicators will light green. You may then remove the rechargeable batteries
and install them into the Nytech DC-8200. Depending on the charge level,
the charging cycle can take up to 4 hours.
!
Always recharge a pair of batteries. Never recharge a single
battery by using the supplied charger.
Remove the rechargeable batteries from the camera when the
device is not to be used for a long time.
During charging, the rechargeable batteries and charging device
will become warm. This is not a malfunction.
To Next Page
Loading...
Need help?
General
