Nytech DC-8200 Introduction
12 - English
Inserting an SD Card
By using the supplied SD memory card you can increase the Nytech DC-
8200 storage capacity for saving your photos, videos and voice recordings.
When the memory card is inserted, all the photos and videos you take will
be saved onto it. If there is no memory card inserted, your photos and
videos will be saved to the internal memory of the camera.
!
Power off the camera using the On/Off switch [2] before you
insert or remove a memory card.
- Open the Nytech DC-8200 battery compartment by
pushing the cover gently outwards. The cover will open
up by a spring mechanism.
- Insert the memory card with
the contacts towards the
rear of the camera into the
card compartment and push
it into the housing. The
memory card clicks into
place.
- Close the battery compartment
cover by pressing down the flap on the housing
of the camera and then by pushing it inwards till it locks.
The cover clicks into place.
- To remove the memory card, open the battery compartment cover and
gently press on the inserted card. This will protrude a little so that you
can get a hold of it and remove it.
!
If the memory card or the internal memory is exhausted, the
message Memory full will appear on the display [12].
To Next Page
Loading...
Need help?
General
