Nytech DC-8200 Introduction
English - 13
Write-Protecting the Memory Card
The memory card features a write-protection tab. When the write protection
is enabled (see the right figure below) you will be able to view any existing
pictures only, but not be able to delete or edit them. Also, it will not be
possible to record any new pictures onto the memory card.
Write protection disabled Write protection enabled
i
If a card with enabled write protection has been inserted and
you're using the camera in capture mode, the message Card
locked will appear on the display [12] and an acoustic signal will
sound.
Switching the Camera On and Off
Press the On/Off button [2] and keep it pressed down for approximately 1
second to turn the camera on in Recording mode. Or you can press the
Play button [5] and keep it pressed down for approximately 1 second to
turn the camera on in Playback mode.
Press the On/Off button [2] to switch the camera off.
Power-Saving Function
The Nytech DC-8200 is equipped with an automatic power-saving function
to extend the rechargeable battery endurance. By default, the LCD display
[12] powers off after one minute if the camera is not being used. Press any
button to power on once again the LCD display.
You can alter the preset timeout for the energy-saving function. To do this,
read page 58 – Power-Saving Function.
To Next Page
Loading...
Need help?
General
