Nytech DC-8200 Introduction
English - 11
Inserting the Batteries
When the batteries are fully charged, insert them into the Nytech DC-8200
as below.
- Open the Nytech DC-8200 battery compartment by pushing the cover
gently outwards. The cover will open up by a spring mechanism.
- Place the batteries into the camera as shown. Always pay attention to
the polarity. To help you, inside the battery compartment there is a
sticker showing the battery polarity.
- In this position the batteries cannot be completely inserted but will be
pressed against the contacts after closing the cover.
- Close the battery compartment cover by pressing down the flap on the
housing of the camera and then by pushing it inwards till it locks. The
cover clicks into place.
To remove the rechargeable batteries,
open the battery compartment and
remove them.
!
When the rechargeable battery is empty the status indicator [7]
will light green, an acoustic signal will sound and the message
Replace battery will appear on the display [12].
Make sure that the camera is switched off before you remove
the rechargeable batteries.
Make sure that the type of power supply has been set properly
(see page 60 - Battery Type).
To Next Page
Loading...
Need help?
General
