Why is my Oasis Commercial Food Equipment system not operating?
If your Oasis Commercial Food Equipment system isn't operating, first, verify that the utility power is on. Next, ensure that the MAIN power switch is turned on. Finally, check the circuit breaker box for any tripped circuits.
What to do if my Oasis Commercial Food Equipment digital control display is blank?
If the digital control display on your Oasis Commercial Food Equipment is blank, start by checking that the MAIN power switch is turned on. If it's on and the display is still blank, check the circuit breaker box for any tripped circuits.
How to fix Oasis Commercial Food Equipment case not holding temperature?
If your Oasis Commercial Food Equipment case isn't holding temperature, consider these potential causes: If a large amount of warm product was added, allow time for the temperature to adjust, ensuring product is pre-chilled in the future. Temperature changes are normal during defrost mode. Ensure the case isn't in direct sunlight or near heat or AC vents. Check that the condenser coil has been cleaned and that air grilles are free from obstructions. Check sight glass for flashing and/or low charge and check if the set point temperature isn't adjusted too high.
Why is my Oasis Commercial Food Equipment case not holding proper temperature?
If your Oasis Commercial Food Equipment case isn't holding the correct temperature, several factors could be responsible. If you've recently added a large amount of warm product, allow some time for the temperature to stabilize, remembering that product should be pre-chilled before being placed in the case. Make sure that the case isn't exposed to direct sunlight or positioned near a heat or air-conditioning vent. Also, temperature fluctuations near front doors can affect the unit's ability to maintain a consistent temperature. Ensure that the filter and condenser coil have been cleaned, and that air return grilles are free from obstructions, avoiding placing any product on the air grilles.
How to troubleshoot Oasis Commercial Food Equipment fan not working?
If the fan in your Oasis Commercial Food Equipment isn't working, first, check that the MAIN power switch is on. Next, ensure that the fan motor is properly plugged in at the fan shroud. Check for any foreign material that might be obstructing the fan's performance, and make sure the fan blades can rotate freely within the fan shroud. Finally, verify that power is going to the fan and that the fan wiring is correctly connected on the terminal blocks.
Why are no case lights working on my Oasis Commercial Food Equipment?
If no case lights are working on your Oasis Commercial Food Equipment, first, check that the light switch is in the 'on' position. Next, make sure that ALL of the light cords and plugs are properly connected. Also, check the circuit breaker box for any tripped circuits. If the lights still don't come on, consider calling a service provider.
What to do if my Oasis Commercial Food Equipment condensing unit is not operating?
If the condensing unit of your Oasis Commercial Food Equipment is not operating, first check that the power is turned on. If it is, determine if the temperature controller settings are properly set. Refer to your case’s serial label for your model’s specified settings.
What to do if my Oasis Commercial Food Equipment case light is not working?
If a case light is not working on your Oasis Commercial Food Equipment, check that ALL of the light cords and plugs are properly connected. If the light still doesn't come on, consider calling a service provider.
What to do if Oasis Commercial Food Equipment control display is flashing?
If the control display is flashing on your Oasis Commercial Food Equipment, see your case’s thermostat label (near temperature controller) for your model’s required settings.
General| Brand | Oasis |
|---|---|
| Model | CO33R |
| Category | Commercial Food Equipment |
| Language | English |
To Next Page