Oasis CO33R - Shimming Frame Support Rails; Adjusting Levelers

8
SHIMMING FRAME SUPPORT RAILS / ADJUSTING LEVELERS
1. Cases With Frame Support Rails: Shim
• Illustration at top-left shows case with frame
support rails.
• Shims will be provided on cases with frame
support rails.
• Use shims to level case.
2. Cases With Levelers: Adjust
• Important! For cases with casters, after case is in
proper position, levelers must then be
LOWERED to floor.
Frame
Support Rails
• Adjust case so it is level and plumb.
• You may need to remove front and/or rear
toe-kick to access levelers.
• Use adjustable wrench (and possibly a pry bar)
to adjust leveler.
• Do not use pry bar on toe-kick (it may buckle).
• Do not use pry bar on end panel (it may chip).
• Use pry bar ONLY on base frame to avoid
damaging case.
• Use a block to reach base frames with pry bar.
• See below-right illustrations.
Pry Bar
Base Frame
Leveler
Adjustable
Wrench