TROUBLESHOOTING (TO BE PERFORMED BY STORE PERSONNEL), CONT’D - PAGE 2 OF 2
42
LED Style Light Fixtures
Removal of faulty LED light:
• LED lights rarely require change-out.
• To remove faulty LED light, simply grasp light
near retaining spring and carefully pull away
from its spring. Disconnect plug from LED’s
socket.
• Contact Structural Concepts’ Technical Service
Department for replacement parts (see
Technical Service section of this manual for
information).
LED’s Oval Form
Plug’s
Oval Form
--- LED Plug & Light Fixture ---
Retaining
Springs
Plug
A
B
LED’s Barrel
Shaped
Insert
LED
Light
“B-Shaped” LED Plug & Light Fixture
“Barrel-Shaped” LED Plug & Light Fixture
Replacement of LED light:
• To replace LED light fixture, simply insert new
LED light at proper position (socket must be near
plug). Carefully snap into metal springs so LEDs
are held firmly in place.
• Note: LED light and plug must be connected in a
specific manner or they will not work.
A. Certain plug designs (“barrel type”) merely require
that plug be pushed all the way in.
B. Other plugs require “oval edge” of plug to
connect to oval edge of LED light.
• See illustrations below.
No Gap
Gap
To Next Page
Loading...