MC 2000
Expandable MIDI Master Controller
94
The modifications made can be memorized by enabling the WRITE Program function,
described in section 4 of this manual. The WRITE Program function can be recalled from
any page or subpage of the Edit Mode, as well as from the main Program Mode page.
When the patch is changed (aborting the modifications) or memorized (WRITE procedure),
the "E" for EDITED disappears.
We will now take a detailed look at the Edit sections, which appear in a list when the
[EDIT] key is pressed:
•
OUT CONFIGURATION
: definition of the activation status of the MIDI OUT port
(including the internal communications port dedicated to the sound board), and the
zone transmission channel.
•
ZONE DEFINITIONS
: definition of the zone Key Range, Transpose and Mode.
•
OUT MESSAGES
: assignment of the messages belonging to the zone, such as
Program Change, Bank Select, Volume, Pan-pot, Reverb and Chorus. The exclusive
system messages are included.
•
CURVES
: section where each zone can be assigned its own dynamic and Aftertouch
curves.
•
SLIDERS
: definition of the sliders assigned to the zone with the relative default value.
•
PEDALS
: definition of the pedals assigned to the zone with the relative default value.
5.2. OUT CONFIGURATION
In this section, also known as the setup section, the user can set the main setup
parameters of the zone such as its basic status, the MIDI OUT port and the MIDI
CHANNEL for transmission.
After selection of the
OUT CONFIG
option from the Edit Mode menu using the procedures
described above, the display will be as shown below:
The fields appearing on the display are:
To Next Page
Loading...
Need help?
General