MC 2000
Expandable MIDI Master Controller
114
The last field in the video page is the "DEFAULT" field, meaning the value which the
selected slider (and thus the relative Control Change) assumes when the patch is recalled.
The values which this field may assume are OFF (default value not transmitted when the
patch is recalled), and 0 127, which can be set using the Data Entry devices after
selecting the field (key [F5] or cursor keys + [ENTER]).
Important note: when setting the default value in a zone for Control Changes 7 (volume),
10 (Pan-Pot), 91 (Reverb) and 93 (Chorus), make sure that this operation has not already
been carried out in the OUT MESSAGES page. To avoid entering contradictory data, it is
advisable to set the default condition as OFF for all those data which might be set in other
sections of the Edit Mode.
Press the [ESC] key to return to the Edit Mode MAIN MENU.
5.7. PEDALS
Pressing the [F6] function key (corresponding to the word "PEDALS") from the Edit Mode
MAIN MENU page gives direct access to the section for definition of the pedals assigned
to each zone. The function can also be selected by locating the cursor on the "PEDALS"
field and confirming with [ENTER].
When this procedure is followed, the following video page will appear on the display:
When the function is accessed, the "ZONE" field is selected; this sets the zone to which
one or more pedals are to be assigned.
To Next Page
Loading...
Need help?
General