MC 2000
Expandable MIDI Master Controller
119
this key is pressed after this, the system will move on one step, and each step will be
loaded automatically.
• [F6] = NEXT function: movement one step forward, with automatic loading.
Once the chain has been performed, press the [ESC] key to return to the chain selection
video page.
Press [ESC] again to return to the Program Mode.
6.4. WRITE CHAIN
Pressing the [WRITE] key provided in the CHAIN EDIT video page will give access to the
WRITE CHAIN procedure, which allows the Chain to be memorized with the modifications
made.
When the [WRITE] key is pressed after this, the LED in the key will begin to flash and the
display will show the following video page:
Press [ESC] to return to the previous page.
As can be seen, the display contains 2 lines, the upper line allowing selection of the
memory location which will house the Chain (indicating the relative name), while the
bottom line contains the "name" field in brackets and in lower case, indicating that in this
case key [F6] recalls the function for assigning a new name to the Chain.
Note that the only function key enabled in this video page is [F6], corresponding to the
"name" function.
The Data Entry devices can be used to select the destination of the Chain in a range from
1 to 64.
Function key [F6] (name) can be used to proceed with renaming of the memory location,
and the display will appear as shown below:
To Next Page
Loading...
Need help?
General