92
Federal Communications Commission (FCC)
Declaration of Conformity (USA only)
declares, that the products
Product Name: fx3000
comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Call the dealer or an experienced radio/TV technician for help.
Important A
Changes or modifications not expressly approved by Océ Imagistics Inc. could void the user’s
authority to operate the equipment.
Important—about the interface cable A
A shielded interface cable should be used to ensure compliance with the limits for a Class B digital
device.
Responsible Party: Océ Imagistics Inc.
100 Oakview Drive, Trumbull
CT 06611, USA
TEL: (203) 365-7000
To Next Page
Loading...
Need help?
General
