Remote fax options
67
9
Remote fax commands
Follow the commands below to access features when you are away from the machine. When you
call the machine and enter your R R Passcode (3 digits followed by l), the system will give two
short beeps and you must enter a remote command.
Remote commands Operation details
95 Change the fax forwarding or
remote retrieval settings
1 OFF You can choose Off after you have retrieved or erased all your
messages.
2 Fax forwarding One long beep means the change is accepted. If you hear three
short beeps, you cannot change because something has not
been set up (for example, a fax forwarding number had not
been registered). You can register your fax forwarding number
by entering 4. (See Changing the Fax Forwarding number on
page 66.) Once you have registered the number, fax
forwarding will work.
4 Fax forwarding number
6 Fax storage
96 Retrieve a fax
2 Retrieve all faxes Enter the number of a remote fax machine to receive stored fax
message(s). (See Retrieving fax messages on page 66.)
3 Erase faxes from the memory If you hear one long beep, fax messages have been erased
from the memory.
97 Check the receiving status
1 Fax You can check whether your machine has received any faxes.
If yes, you will hear one long beep. If no, you will hear three
short beeps.
98 Change the answer mode
1 External TAM If you hear one long beep, your change has been accepted.
2 Fax/Tel
3 Fax Only
90 Exit Press 9, 0 to exit remote retrieval. Wait for the long beep, then
replace the handset.
To Next Page
Loading...
Need help?
General
