PIZZAFORM
General specifications and warning
GB - 4
1.5 - PREARRANGEMENTS AT
PURCHASER’SCHARGE
a) Prearrangement of the installation place.
• The purchaser shall prearrange a supporting surface
for the machine as indicated in the chapter
“Installation”.
b) Electric prearrangement.
• The po wer system should comply with the local
regulations and provided with an efficient earthing.
• Place an omnipolar sectioning device on the power
feed line, above the machine.
• The size of the electric po wer cables should
comply with the maximum current required by
the machine, so that the total voltage drop at
full charge will be less than 2%.
c) Neutral wire
• The machine is equipped with neutral wire, therefore,
a special ter minal being identified according to the
relevant directions has been prearranged.
1.6 - EMERGENCY OPERATIONS IN CASE OF
FIRE
a)
In case of fire tur n off the po wer by disconnecting
the main power switch.
b) Put out the fire by means of suitable fire extinguishers.
DANGER
Do not attempt to put out the fire by using water.
1.7 - EXPLOSION RISK
•
The machine is not suitab le to be used in a place
with explosion risk.
1.8 - SOUND PRESSURE LEVEL
PRESSFORM machines have been developed to keep
the continuous equivalent weighted acoustic pressure
level A(dB) lower than 70dB during machine idle strokes.
To Next Page
Loading...
