4.3. Obligations and prohibitions
4.3.1. User obligations
The user (entrepreneur or employer) must:
• consider the abilities and conditions of the operators in relation to their health and safety;
• provide the appropriate means of individual protection conform to each procedure;
• Provide standard lifting means and procedures;
• Require individual workers to comply with company rules and regulations on safety and the use of
collective and individual protections;
• educate staff on accident procedures;
• educate staff about residual risks;
• educate staff on operator safety devices;
• educate staff on the general safety rules provided by European directives and the legislation of the
country where oven is targeted.
Only personnel who have seen this manual and properly trained can operate on the machine.
4.3.2. Staff obligation (operators/maintainers/technicians)
The Staff has to:
• Perform maintenance always with the machine off.
• Perform interventions on all components of the electrical system always with the general switch off.
• When you start the machine, make sure that there is no foreign object inside.
• appropriately use the protective equipment provided by the employer.
• Report safety device deficiencies to your employer, manager, or supervisor immediately.
4.3.3. Staff prohibition (operators/maintainers/technicians)
In particular, the staff mustn’t:
• use the machine improperly, that is, for uses other than those indicated in the paragraph "Correct
Use";
• remove or modify security or signaling devices without permission;
• carry out operations on their own initiative or that may compromise the safety of their own or
other workers;
• change the operation of the machine;
• modify electrical connections to exclude internal security;
• use the oven if not installed according to the applicable regulations;
• use the oven outside of the allowed environmental conditions (see "chapter 5").
To Next Page
Loading...
