What to do if the lid releases during a power failure on my OHAUS Laboratory Equipment?
If you experience a lid release during a power failure with your OHAUS Laboratory Equipment centrifuge, switch the centrifuge off and unplug it. Remove the plastic stopper on the left side. Pull the string to open the lid while pressing it slightly. Replace the string and plastic stopper, then switch the centrifuge back on.
Why has the imbalance switch been activated for longer than 5 seconds in my OHAUS Laboratory Equipment?
The imbalance switch may have been activated on your OHAUS Laboratory Equipment because it is incorrectly adjusted or defective, or due to a cable break, loose plug between the control unit and frequency converter, or a defective control unit.
Outlines safety measures for users, rotor/accessory handling, and environmental considerations.
General guidelines and safety instructions for performing service on the centrifuge.
Guide to activating the service menu and accessing submenus for diagnostics and settings.
Accessing the second service menu level for model verification and imbalance cut-off value adjustment.
General guidelines for routine maintenance, cleaning, and disinfection.
Procedures for cleaning and disinfecting the centrifuge unit and its components.
Guide to diagnosing and resolving common issues and error messages.
A comprehensive list of error codes, their descriptions, and probable causes.
General| Model | FC5706 |
|---|---|
| Display | LCD |
| Operating Temperature | 10 °C to 30 °C |
| Power Supply | AC Adapter (Included) |
| Interface | RS232 |
| Stabilization Time | 3 seconds |
| Units of Measurement | g, kg, lb, oz |
To Next Page
