CONTENT
Ohaus Corporation www.ohaus.com FC5706 Service Manual
centrifuge and or its accessories. When centrifuging infectious substances, always pay attention to
the general laboratory precautions. If necessary, contact your safety officer!
It is prohibited to run the centrifuge with rotors other than listed for this unit.
Under no circumstances open the lid of the centrifuge while the rotor is still running or rotating with a speed of
> 2m/s
1.4 SERVICE FACILITIES
To service a centrifuge, the service area should meet the following requirements:
Area must be clean and air must not contain excessive dust particles.
Work surface must be stable and level.
Use an approved Electro-Static Device.
1.5 TOOLS AND TEST EQUIPMENT REQUIRED
1.5.1 Standard Tools and Test Equipment
1. Flat and Philip screws drivers, tweezers, adjustable open wrenches and socket set (with
drive socket sets from 4mm-14mm, Ratchet and drive extension bar.)
To Next Page
Loading...
