Oki B4300 - Page 49

Configuration 47
TCPIP-9 [OKI Device
Setup]-
[General]-
[Change root
password]
[Setup TCP/IP]-
[root password]
Any
alphanumeric
characters up
to seven
characters.
(Default is null)
Set the root
password of
OkiLAN
SNMP-1 [OKI Device
Setup]-
[SNMP]-
[Authentic
Community]
[Network
Configuration]-
[SNMP Traps]-
[MIB-II
Information]-
[Authentic
Community]
[Setup SNMP]-
[Authentic
community]
Any
alphanumeric
characters up to
15 characters.
(Default is
[public])
This
community
name is used to
check whether
incoming
SNMP
requests have
the correct
community
name or not.
The
community
name is
displayed as
****** for
security
reasons
SNMP-2 [OKI Device
Setup]-
[SNMP]-
[TRAP
Community]
[Network
Configuration]-
[SNMP Traps]-
[MIB-II
Information]-
[Trap Community]
[Setup SNMP]-
[Trap community]
Any
alphanumeric
characters up to
15 characters.
(Default is
[public])
This
community
name is
assigned to
outgoing
system traps
such as cold
start, authenti-
cation failure,
etc.
SNMP-3 [OKI Device
Setup]-
[SNMP]-
[TRAP
Address]
[Network
Configuration]-
[SNMP Traps]-
[MIB-II
Information]-
[Trap IP Address]
[Setup SNMP]-
[Trap address]
0.0.0.0—
255.255.255.255
(0.0.0.0)
Set a
destination IP
address of
Trap packet. If
0.0.0.0 is set,
Trap is
disabled
SNMP-4 [OKI Device
Setup]-
[SNMP]-
[SysContact]
[Network
Configuration]-
[General Settings]-
[System
Information]-[System
Contact]
[Setup SNMP]-
[SysContact]
Any
alphanumeric
characters up to
255 characters.
(Default is null)
Set SysContact
(printer
manager)
name
SNMP-5 [OKI Device
Setup]-
[SNMP]-
[SysName]
[Network
Configuration]-
[General Settings]-
[System
Information]-
[System Name]
[Setup SNMP]-
[SysName]
Any
alphanumeric
characters up to
255 characters.
(Default is null)
Set SysName
(printer model
name)
Ref. No. Admin
Manager
Web browser TELNET/
Diagnostic test
print
Available
options
Notes