Oki B4300 - Page 50

Configuration 48
SNMP-6 [OKI Device
Setup]-
[SNMP]-
[SysLocation]
[Network
Configuration]-
[General Settings]-
[System
Information]-
[System Location]
[Setup SNMP]-
[SysLocation]
Any
alphanumeric
characters up to
255 characters.
(Default is null)
Set Sys-
Location (the
location where
the printer is
installed)
SNMP-7 [OKI Device
Setup]-
[SNMP]-
[Default TTL]
[Setup SNMP]-
[DefaultTTL]
0—255 Set TTL (Time
To Live) value
SNMP-8 [OKI Device
Setup]-
[SNMP]-
[Enable Authen
Trap]
[Network
Configuration]-
[SNMP Traps]-
[MIB-II
Information]-[Enable
AuthenTraps]
[Setup SNMP]-
[EnableAuthenTra
p]
1 (Enable)/
2 (Disable)
Set Authentic
Trap, enabled/
disabled
NetWare-1 [OKI Device
Setup]-
[NetWare]-
[Use NetWare
Protocol]
[Network
Configuration]-
[General Settings]-
[Protocol Options]-
[NetWare]
[Setup NetWare]-
[NetWare
protocol]
ENABLE/
DISABLE
Set NetWare
protocol,
enabled/
disabled
NetWare-2 [OKI Device
Setup]-
[NetWare]-
[Frame Type]
[Network
Configuration]-
[General Settings]-
[Frame Options]-
[NetBEUI]
[Setup NetWare]-
[Packet type]
ETHER-II/
802.3/802.2/
SNAP/AUTO
Set primary
NetWare
packet type
NetWare-3 [OKI Device
Setup]-
[NetWare]-
[Operation
Mode]
[Network
Configuration]-
[NetWare]-[NetWare
Selections]-[NetWare
Mode]
[Setup NetWare]-
[NetWare mode]
RPRINTER/
PSERVER
Set NetWare
mode
NetWare-4 [OKI Device
Setup]-
[NetWare]-
[Bindery
Setup]-
[Selected file
server]
[Network
Configuration]-
[NetWare]-[File
Server for PServer
Mode]-[File Server
Names]
[Setup NetWare]-
[Setup PSERVER
mode]–
[FSERVER name
1—8]
Any
alphanumeric
characters up to
47 characters.
(Default is null)
Set file servers
to connect.
Up to eight file
servers can be
set.
If you have
nine or more
file servers,
you should set
file servers
here
NetWare-5 [OKI Device
Setup]-
[NetWare]-
[Print Server
Name]
[Network
Configuration]-
[NetWare]-[PServer
Mode]-[NetWare
Print Server Name]
[Setup NetWare]-
[Setup PSERVER
mode]– [Machine
name]
Any
alphanumeric
characters up to
31 characters.
(Default is [OL]
+ last six digits
of MAC
address)
Set Print
Server name
Ref. No. Admin
Manager
Web browser TELNET/
Diagnostic test
print
Available
options
Notes