Oki B4300 - Page 51

Configuration 49
NetWare-6 [OKI Device
Setup]-
[NetWare]-
[Bindery
Setup]-
[Password]
[Network
Configuration]-
[NetWare]-[PServer
Mode]-[Password]
[Setup NetWare]-
[Setup PSERVER
mode]–
[Password]
Any
alphanumeric
characters up to
31 characters.
(Default is null)
Set password
for Print
Server
NetWare-7 [OKI Device
Setup]-
[NetWare]-
[Bindery
Setup]-[Job
Polling Time]
[Network
Configuration]-
[NetWare]-[PServer
Mode]-[Job Polling
Rate]
[Setup NetWare]-
[Setup PSERVER
mode]– [Job
polling interval]
2—255 (4) Set print job
polling interval
in seconds
NetWare-8 [OKI Device
Setup]-
[NetWare]-
[Bindery
Setup]
[Network
Configuration]-
[NetWare]-[PServer
Mode]-[Bindery
Mode]
[Setup NetWare]-
[Setup PSERVER
mode]–[Bindery
mode]
ENABLE/
DISABLE
Set bindery
mode, enabled/
disabled.
Set DISABLE
if you use
OkiLAN as
PSERVER on
NDS
NetWare-9 [OKI Device
Setup]-
[NetWare]-
[NDS Setup]-
[NDS Tree]
[Network
Configuration]-
[NetWare]-[NDS]-
[Tree Name]
[Setup NetWare]-
[Setup PSERVER
mode] – [NDS
tree]
Any
alphanumeric
characters up to
31 characters.
(Default is null)
Set NDS Tree
name
NetWare-10 [OKI Device
Setup]-
[NetWare]-
[NDS Setup]-
[NDS Context]
[Network
Configuration]-
[NetWare]-[NDS]-
[Context]
[Setup NetWare]-
[Setup PSERVER
mode] – [NDS
context]
Any
alphanumeric
characters up to
77 characters.
(Default is null)
Set NDS
context for
Print Server
NetWare-11 [OKI Device
Setup]-
[NetWare]-
[RPRINTER
Setup]-
[Selected print
server]
[Network
Configuration]-
[NetWare]-[Remote
Printer Mode]-
[NetWare Print
Server Names]
[Setup NetWare]-
[SET RPRINTER
mode] –
[PSERVE name
1—8]
Any
alphanumeric
characters up to
47 characters.
(Default is null)
Set print
servers to
connect.
Up to eight
print servers
can be set.
If you have
nine or more
print servers,
you should set
print servers
here
NetWare-12 [OKI Device
Setup]-
[NetWare]-
[RPRINTER
Setup]-[Time
Out]
[Network
Configuration]-
[NetWare]-[Remote
Printer Mode]-
[Job Timeout]
[Setup NetWare]-
[SET RPRINTER
mode]–[Job
timeout]
4—255 (10) Set duration
from the last
data’s arrival
to freeing the
port in seconds
EtherTalk-1 [OKI Device
Setup]-
[EtherTalk]-
[Use EtherTalk
Protocol]
[Network
Configuration]-
[General Settings]-
[Protocol Options]-
[EtherTalk]
[Setup EtherTalk]-
[EtherTalk
protocol]
ENABLE/
DISABLE
Set EtherTalk,
enabled or
disabled
Ref. No. Admin
Manager
Web browser TELNET/
Diagnostic test
print
Available
options
Notes