Operation > 119
Creating:
To register a short cut:
1. Press the Job Program button on the control panel to prompt the Job Programs
screen.
2. Select a job number you wish to associate to your program.
3. Select Yes to continue, or No to exit without saving.
4. Key in the steps you wish to program; for example if you wish to program a copy job
that is double-sided, A4(SEF) scan size and the output is 20 copies:
(a) Press the Copy button on the control panel.
(b) Press the Others button on-screen.
(c) Press the DuplexCopy button on-screen.
(d) Press the 1->2 sides button on-screen.
(e) Press the Enter button on-screen.
(f) Press the Scan Size button on-screen.
(g) Press the A4(SEF) button on-screen.
(h) Press the Enter button on-screen.
(i) Press the Close button on-screen.
(j) Using the numerical keypad, type in 20.
5. Press the Job Programs button on the control panel.
6. Using the on-screen keypad type in an appropriate title for the program.
7. Press the Enter button on-screen to complete the registration.
Using:
To use a pre-programmed short cut:
1. Press the Job Program button on the control panel to prompt the Job Programs
screen.
2. Select the job number you wish to use.
3. At the prompt, select Yes to execute the program or No to exit.
Deleting:
To delete a Job Program function:
1. Press the Setup button on the control panel to prompt the Setup screen.
2. Press the Job Programs Setting button.
NOTE
Maximum of 60 steps per program; selecting or pressing a button counts as
one step.
It is a good idea to write down the steps to be performed beforehand as every
keystroke/button press is programmed.
NOTE
You cannot edit the steps within a program, if you wish to change them then
you must reprogram the job number.
To Next Page
Loading...
Need help?
General
