Getting started > 25
F
ACE
UP
STACKER
The face up stacker at the rear of the MFP should be opened and the tray extension pulled
out when required for use. In this condition paper will exit via this path, regardless of driver
settings.
The face up stacker can hold up to 100 sheets of 80g/m² standard paper, and can handle
stocks up to 200g/m².
Always use this stacker and the multi purpose feeder for paper stocks heavier than
128g/m².
D
UPLEX
UNIT
The duplex unit provides automatic two-sided printing on the same range of paper sizes as
tray 2 (i.e. all cassette sizes except A6), using paper stocks from 64-105g/m².
To Next Page
Loading...
Need help?
General
