Troubleshooting > 163
MFP is set for delayed transmission but it did not send. Check the display to make
sure that the MFP is set to the correct time and date (see “Time Setup” on page 63).
MFP will not poll a remote machine. Call the person at the remote machine and make
sure that they have loaded documents and that their machine is set to polling transmission
mode.
MFP is connected to a PBX but it is not possible to dial out. Be certain that the dial
prefix is entered before the telephone number for each number dialled or programmed into
the MFP (see “PreFix” on page 43).
MFP always answers before its possible to use the external telephone. If an
external telephone is connected, change the MFP’s ring response setting (“Ring Response”
on page 43). Also check the reception mode setting of the machine (see “Reception Mode”
on page 63).
Faxes received sometimes look distorted. If the document received is wider or longer
than the paper loaded in the paper tray, the machine automatically reduces the width or
length of the document so that it will fit on the paper. This type of problem could also be
communication related.
I
NFORMATION
AND
ERROR
MESSAGES
NOTE
1. <%COLOR%> = Y, M, C or K.
2. <%TRAY%> = Tray 1, Tray 2, Tray 3 or MP Tray.
3. mmm = the setup of “paper size”.
4. ppp = the setup of “media type”.
STATUS /
CODE
MESSAGE MEANING / ACTION
Initializing Check Data
Program Data Receive Error <%DLCODE%>
An error occurs while the machine is
receiving/processing the NIC download data.
%DLCODE%
1. File size error
2. Check SUM error
3. Invalid printer model number
4. Invalid module I/F version
5. Invalid FAT version
Restart the machine. (Turn it off and on
again).
If the code still appears, contact your dealer.
Initializing Check Data
Program Data Write Error <%DLCODE%>
An error occurs when writing NIC download
data.
%DLCODE%
1. Memory allocation error
2. Download file error
3. Device allocation error
4. No device space
5. File writing failure
6. CU-F/W mismatch.
Restart the machine. (Turn it off and on
again).
If the code still appears, contact your dealer.
To Next Page
Loading...
Need help?
General
