Configuring your machine... > 30
N
ETWORK
SET
UP
The MFP must also be set up properly on your network to perform scan to e-mail and scan
to FTP functions. In order for other network devices to find the MFP on the network, the
following network parameters have to be set.
1. IP Address Set:
2. IP Address: . . .
3. Subnet mask:. . .
4. Gateway IP:. . .
5. DNS server:. . .
6. SMTP server:. . .
7. SMTP port:25
8. POP3 server: . . .
9. POP3 Port:110
Explanation:
1. IP Address Set:
Choose Auto to obtain IP/subnet/gateway addresses automatically from DHCP server.
After changing setting from Manual to Auto, the MFP will automatically reboot the
network card.
2. IP Address:
The Internet Protocol (IP) address assigned to your machine by your network
administrator.
3. Subnet Mask:
The net mask address assigned by your network administrator.
4. Gateway IP:
The gateway IP address assigned by your network administrator.
5. SMTP Server:
The IP address of your SMTP Mail Server assigned by your network administrator.
6. SMTP Port:
The port number of your SMTP Mail Server.
7. DNS server:
The IP address of DNS Server assigned by your network administrator.
8. POP3 Server:
The IP address of your POP3 server.
9. POP3 Port
The port number of your POP3 Server.
Enter the DNS name, or IP and port number of your POP3 server if your mail server
requires POP3 authentication, before sending e-mails from the machine.
NOTE
You must also set up the “From” details to allow e-mail sending.
To Next Page
Loading...
Need help?
General
