Oki ML1120 User Manual

ML1120/ML1190 eco User’s Guide – Troubleshooting > 90
Too high or too low TOF
(where printing starts).
The TOF is not correctly
selected.
Initialise the printer.
Select correct TOF for
cut sheet and
continuous forms.
Select the first-line print
position and adjust the
paper top position.
Reselect the margin
correctly in the
application.
Too large or small left
and/or right margins.
The left or right margin
is not correctly
selected.
Incorrect positions of
the Paper Guide or Pin
Tractors. Select and
adjust the position
again depending on the
paper type.
Reselect the left and
right margins correctly
in the application.
When continuous forms
are used, the content of
a single form is printed
on two forms.
The paper length
selected in the
application does not
match the physical
paper length.
Match the paper length
selected in the
application with the
physical paper length in
use.
When cut sheets are
used, the content of a
single sheet is printed
on two sheets.
The paper setting
selected in the
application does not
match the physical
paper size.
Match the paper setting
selected in the
application with the
physical paper in use.
It does not match the
lines per page as the
printer automatically
detected.
Leave enough top and
bottom margin in the
application.
Correct the cut sheet LF
adjustment.
The content of a single
line is printed in two
lines.
The left and/or right
margins are not
correctly selected.
Reselect the left and
right margins correctly
in the application.
When continuous forms
are used, several blank
lines appear in the
printout.
Tear-off perforation
spacing is selected.
Cancel tear-off
perforation spacing.
PROBLEM CAUSE ACTION

Oki ML1120 Specifications

General

Noise level	49.7 dB
Maximum duty cycle	18000 pages per month
Maximum number of copies	9 copies
Power requirements	120 - 220V
Dimensions (WxDxH)	889 x 587 x 379 mm

Weight and Dimensions

Dimensions (W x D x H) (imperial)	35 x 23.1 x 14.9 \