2
2 Safety Notes
In order to achieve maximum performance and to ensure proper operation of your new equipment, please
read carefully the following safety notes and the instructions. If you have any question, please contact Okolab.
− This equipment must be used only as intended and described in this Manual.
− This equipment should be operated only by qualified personnel.
− Do not use this equipment if any parts are damaged.
− This instrument is not intended for use in locations subject to flammable or explosive gases.
− Always transport equipment with care.
− The equipment and its internal parts may be damaged by dropping or shock.
− Do not use a volatile solvent, such as paint thinner, to clean the instrument, deformation or
discoloration will occur.
− Use a soft, dry cloth to remove stains from the instrument.
− Not following these instructions could damage the device and its accessories.
− Do not exceed the voltages indicated in this manual or on the product label.
− Avoid excessive induction noise, static electricity, or magnetic fields.
− Do not expose this instrument to water or moisture.
− Avoid throttling and kinking of tubes.
− Check tubing from time to time for possible wear and tear.
− Check that all tubing is fully inserted into connectors, and secure.
− This device is not designed for use in medical applications.
International caution symbol marks this device. It is important to read the “Safety Notes” before
installing, using and commissioning this device, as the notes contain important information relating
to safety and EMC. Not following these instructions can result in damage or breakdown of the device
and its accessories.
We reserve the right to make technical upgrades and changes.
IN NO EVENT, SHALL OKOLAB S.R.L. BE LIABLE FOR ANY DIRECT, INCIDENTAL, OR CONSEQUENTIAL
DAMAGES OF ANY NATURE – INCLUDING: LOSSES OR EXPENSES RESULTING FROM ANY DEFECTIVE PRODUCT,
OR THE USE OF ANY PRODUCT.
To Next Page
Loading...
