Oldham iTrans User Manual

iTrans Fixed Point Single/Dual Gas Monitor System Wiring
(P/N: 77023554-1) iTrans User Manual 4-13
NOTE: If adding a second sensor to an existing module, set the ModBus address
to  which represents 11110000 binary (and 240 decimal). See
Chapter 6 for more information on the ModBus interface. (Note that DIP switches
are pre-set at the factory for all dual-sensor units).
4.7. Wiring Conclusion
Once wiring is complete, place the electronics module back in the
housing by pressing the standoff banana jacks into the mating plugs. Be careful
not to pinch any of the wiring. After the module is in place, secure the windowed
top back on the housing and power up the unit.
  

Oldham iTrans Specifications

General

Brand	Oldham
Model	iTrans
Category	Measuring Instruments
Language	English