Oldham iTrans

iTrans Fixed Point Single/Dual Gas Monitor Operation
(P/N: 77023554-1) iTrans User Manual 5-13
5.6.9. Set System Time – Month
The system’s month setting is
designated with an “E” in the status bit
and current value next to it. To
change the month, press the “”
button during the 10-second
countdown. If you do not press “”
during the 10-second countdown, the
will return to the Normal
Operating Mode. If you initiate the
month option, the status bit will start
to flash and the month value
can be changed by using the “” and
“” keys.
Figure 5-22. Setting System Month
When the desired value is reached, press the “” key. If the value is not saved
before the time-out, the will go back to the Programming Mode.
5.6.10. Set System Time – Year
The system’s year setting is designated
with an “8” in the status bit and
current value next to it. To change the
year, press the “” button during the
10-second countdown. If you do not
press “” during the 10-second
countdown, the will return
to the Normal Operating Mode”. If
you initiate the year option, the status
bit will start to flash and the
year value can be changed by using
the “” and “” keys.
Figure 5-23. Setting System Year
When the desired value is reached, press the “” key. If the value is not saved
before the time-out, the will go back to the Programming Mode.
5.6.11. Zeroing
Zeroing is an option available both through the keypad and non-intrusively. A “0 ”
is displayed in the status bit of the display to designate this function. A 10 second
timer is displayed on the bottom line of the LED display.