Oldham iTrans

iTrans Fixed Point Single/Dual Gas Monitor Introduction
(P/N: 77023554-1) iTrans User Manual 1-3
Table 1-2. Sensor Ranges
Sensor
Gas
Range/Resolution
Combustible Gases
LEL
0 -100% LEL in 1% increments
Hydrogen
H
2
0 - 999 ppm in 1 ppm increments
Oxygen
O
2
0 - 30.0% by vol. in 0.1% increments
Ammonia
NH
3
0 - 500 ppm in 1 ppm increments
Carbon Monoxide
CO
0 - 999 ppm in 1 ppm increments
Carbon Monoxide/H
2
Null
CO
0 - 999 ppm in 1 ppm increments
Hydrogen Sulfide
H
2
S
0 - 500 ppm in 1 ppm increments
Sulfur Dioxide
SO
2
0.2 - 99.9 ppm in 0.1 ppm increments
Hydrogen Cyanide
HCN
0.2 – 30.0 ppm in 0.1 ppm increments
Hydrogen Chloride
HCl
0.2 - 30.0 ppm in 0.1 ppm increments
Phosphine
PH
3
0 - 1.00 ppm in 0.01 ppm increments
Nitrogen Dioxide
NO
2
0.2 - 99.9 ppm in 0.1 ppm increments
Nitric Oxide
NO
0 - 999 ppm in 1 ppm increments
Chlorine
Cl
2
0.2 - 99.9 ppm in 0.1 ppm increments
Chlorine Dioxide
ClO
2
0.02 - 1.00 ppm in 0.01 ppm increments
1.3. Agency Approvals
The is certified by CSA, a NRTL laboratory, to the following US and
Canadian Standards.
 UL Std No. 916-Energy Management Equipment
 UL Std No. 1203-Explosion-Proof and Dust-Ignition-Proof
o Electrical Equipment for Use in Hazardous (Classified) Locations
 UL Std No. 1604-Division 2 Hazardous Location Electrical Equipment
 ISA S12.13 Part I-2000-Performance Requirements, Combustible Gas
Detectors (catalytic sensors only)
 CSA Std C22.2 No.30-M1986-Explosion-Proof Enclosures for Use in
Class I Hazardous Locations
 CSA Std C22.2 No.142-M1987-Process Control Equipment