Oldham iTrans

iTrans Fixed Point Single/Dual Gas Monitor Index
INDEX
Appendix
F
Index
Locator page numbers appear in regular type faces for standard index references
(e.g., 3-7). Boldface index references (e.g., 3-3) correspond to information found
in photos or illustrations. Italic index references (e.g., 3-3) correspond to
information found in tables.
Numbers
#18 AWG........................................4-1, 4-4, 4-7, 5-17
120-Ohm terminating resistor ................................ 6-7
4-20 mA output(s) .. iii, 1-1, 1-2, 4-3, 5-1,, 5-11, 5-16,
8-1, 8-2, 8-3, C-1, C-2
changing upper range ...................................... 5-10
fault ................................................................... 5-2
fixed lower range ............................................ 5-10
not using............................................................ 4-4
A
abbreviations .......................................................... A-1
access code ............................................................ 5-8
accuracy ............................................................. ii, 2-2
acronyms................................................................ A-1
address
selection ............................................................ 1-2
setting ................................................................ 4-9
unique ............................................................... 6-1
agency approvals ................................................... 1-3
air flow................................................................... 3-1
alarm(s)
activation........................................................... 1-1
condition ............................................................. iii
date .................................................................... 5-4
horns ................................................................. 1-1
indication .......................................................... 5-2
month ................................................................ 5-4
over-range alarm ................................................. iii
relays ................................................................. 1-2
capacity ........................................................ 1-2
wiring (J1, J5, J6) ......................................... 4-2
aluminum ............................................... 1-2, 2-1, 4-10
ammonia ........................................................ 1-3, C-1
analog signal ........................................................ 5-10
anticipated life ....................................................... 7-1
apply calibration gas .............................................. 5-6
arrow keys ........................ 5-9, 5-10, 5-11, 5-12, 5-13
atmospheric pressure ................................. iii, 1-2, 7-1
B
banana jacks ......................................................... 4-12
baud rate ................................................................ 6-1
BBIR ............................ 4-4, 5-1, 5-16, 5-17, 6-2, A-1
address ............................................................ 5-17
calibrating ....................................................... 5-16
calibration time ...................................... 5-16, 5-17
span reserve .................................................... 5-17
zero time ................................................ 5-16, 5-17
binary ............................................................. 4-9, A-1
blue jumper ............................................................ 6-7
broadband infrared ....................... 5-1, 5-16, 5-17, A-1
C
cable entry device .................................................. 2-5
calibration 1-1, 5-4, 5-6, 5-7, 5-14, 5-17, 6-4, 6-6, 7-1,
7-2, 8-1, 8-2, A-3, B-1
aborting ............................................................. 5-6